Home / RC Airplane ESCs / E-flite 80-Amp Pro Switch-Mode BEC Brushless ESC V2: EC5
  • E-flite 80-Amp Pro Switch-Mode BEC Brushless ESC V2: EC5
  • E-flite 80-Amp Pro Switch-Mode BEC Brushless ESC V2: EC5

E-flite 80-Amp Pro Switch-Mode BEC Brushless ESC V2: EC5

Quantity
ADD TO CART
BUY IT NOW
  • Detail

    Overview

    When performance matters in your high-current applications, look no further than the E-flite® 80-amp Pro switch-mode ESC. This is a high-quality, efficient sensorless brushless electronic speed control with an integrated switch-mode BEC. It can operate without the need for a separate receiver battery to power your servos and receivers, saving you weight and complication. It is capable of up to 80 amps continuous current when using 3- to 6-series Li-Po battery packs. You can drive up to 7 analog or 6 digital standard-size servos with the BEC on any recommended input voltage. Featuring an exposed, finned heat sink aluminum case with lightweight plastic end-caps, safe power-arming along with advanced programmable features such as low voltage cutoff, braking, timing, throttle input range and more, the E-flite 80-amp Pro switch-mode ESC is truly a ‘pro series’ electronic speed control.

    This product is not intended for use by children under 14 years of age without direct adult supervision.

    Key Features

    • Up to 80 amps continuous current with proper air flow and 100 amps burst current (15 seconds)
    • 5V switch-mode BEC capable of 5 amps continuous current with 6 amps max burst on any recommended input voltage
    • Drive up to 7 analog or 6 digital standard-size servos with the BEC on any recommended input voltage
    • 3- to 6-cell Li-Po, 9- to 18-cell Ni-MH/Ni-Cd input voltage
    • Programmable motor braking
    • Safe power-arm mode prevents accidental starts
    • Programmable low voltage cutoff with settings for 3-cell Li-Po (9.2V), 4-cell Li-Po (12V), 5-cell Li-Po (15V), 6-cell Li-Po (18V) or 74% of battery starting voltage
    • Programmable throttle input range (1.1ms–1.9ms or 1.2ms–1.8ms)
    • Programmable soft start-up rate - .25 second or 1 second
    • Auto motor shut down if signal is lost or there is interference
    • Programmable timing—5 user-selectable ranges–use with a large variety of brushless motors
    • Two operating modes–Airplane or Heli
    • Pre-wired connectors—E-flite EC5 on battery input and 4.0mm female gold bullets on motor output leads
    • NOTE: Not recommended to use with E-flite Power 60 Brushless Outrunner (EFLM4060B)

    Product Specs

    Amperage
    80A
    Auto Cutoff
    Yes
    BEC Continous Current
    5A
    BEC Voltage
    5.5V Switch-mode
    Brakes
    Yes
    Connector Type
    EC5
    Forward
    Yes
    Maximum Burst Current
    100A
    Output Connector
    4mm Bullet
    Overload Protection
    Yes
    Part Type
    Electronics
    Programmable
    Yes
    Time Delay Brake
    Yes
  • Customer Reviews
    No comments
BACK

You May Also Like